Fridge regassing

Fridge regassing in Gauteng, with the leak fixed first

If your fridge runs all day but never gets cold, it may have lost its refrigerant gas. We find the leak, repair it and regas your fridge properly, so it stays cold for years, not weeks.

  • 25 years' experience5,000+ fridges repaired
  • 300+ five-star reviewsFrom Gauteng customers
  • Open 24/7With you in about 1 hour
  • 6-month warrantyOn repairs and regassing

Signs your fridge needs regassing

Refrigerant gas is what carries heat out of your fridge. When some of it leaks out, the fridge keeps running but cannot move enough heat, so the inside slowly warms up. These are the usual signs:

  • The fridge runs constantly but never gets cold enough, and food spoils faster than it should.
  • Only part of the cooling plate or freezer frosts over, often just the corner nearest the pipes.
  • The freezer is soft and the fridge section is warm, even though the motor is running.
  • You hear hissing or gurgling, or see oily marks where the pipes join.
  • Cooling stopped soon after someone chipped ice out of the freezer with a knife or screwdriver.
  • The compressor runs but the sides or back of the fridge, where the heat normally comes out, stay cool.

None of these signs proves a gas leak on its own. A failed fan, a blocked defrost system or a faulty thermostat can produce the same symptoms, which is why we always test before quoting for a regas. Our guide to a fridge not cooling covers the other causes.

Regassing versus a quick gas top-up

Your fridge is a sealed system. The same small charge of refrigerant circulates for the whole life of the fridge and is never used up. So if a fridge is short of gas, there is a leak, full stop.

A quick top-up adds gas without fixing that leak, so the new gas escapes the same way and you pay twice. Adding gas without vacuuming the system also leaves air and moisture inside, which can block the narrow capillary tube and shorten the life of the compressor. A proper regas deals with the cause, not just the symptom.

Our fridge regassing process

  1. Diagnosis. We check the compressor, fans, thermostat and defrost system and read the system pressures to confirm that low gas really is the fault.
  2. Leak detection. We trace the leak with electronic leak detection and bubble testing. Common spots are the evaporator in the freezer, joints where copper meets aluminium, and pipes that rub against the cabinet.
  3. Leak repair. We repair or replace the damaged section and fit a new filter drier, which traps moisture and debris inside the system.
  4. Pressure test. We pressurise the system with dry nitrogen and check that the repair holds.
  5. Vacuum. We pull a deep vacuum to remove air and moisture. This step is what makes the difference between a regas that lasts and one that does not.
  6. Recharge by weight. We recharge with the exact refrigerant and amount listed on your fridge's rating plate. Domestic fridges hold a small charge, often well under 100 grams, so getting the amount right matters.
  7. Test. We run the fridge, check the temperatures and make sure everything is working before we leave your home.

We also regas chest and upright freezers and commercial fridges the same way.

Which gas does my fridge use?

Look at the rating plate, usually a sticker inside the fridge compartment or on the back. It lists the refrigerant type and charge. Most fridges sold in South Africa over the last decade use R600a (isobutane), a natural refrigerant that is kind to the ozone layer but flammable, so it must be handled with care and no open flames. Many older and some imported fridges use R134a, and many newer commercial plug-in units use R290 (propane), which is also flammable. Very old fridges may still contain R12, a phased-out CFC gas, and these are usually better replaced than regassed.

Never mix refrigerants

A fridge must be recharged with the refrigerant it was designed for. Mixing gases or "converting" a system without the right parts causes poor cooling and compressor damage. We always use what is on the rating plate.

What causes refrigerant leaks?

  • Defrosting with sharp tools. One slip with a knife punctures the evaporator.
  • Corrosion. Aluminium evaporators and copper-to-aluminium joints corrode over time, especially in humid kitchens.
  • Vibration. Pipes that rub against the cabinet or each other slowly wear through.
  • Moving house. Pipes and joints get knocked or bent when a fridge is moved carelessly.
  • Hidden condenser pipes. Many modern fridges run their condenser pipes inside the cabinet walls. If one of these leaks, we explain the options, such as fitting an external condenser, before doing more work.

How much does fridge regassing cost?

The price depends on where the leak is, how easy it is to reach, which refrigerant your fridge uses and which parts are needed. Leaks inside the cabinet walls and compressor problems cost more. Our call-out fee is R300, and it is only charged if you decide not to go ahead with the quoted work.

Job Price
Call-out and diagnosis R300, only charged if you do not go ahead with the quoted repair
Fridge regas (leak repair, vacuum and recharge) [PLACEHOLDER]
Compressor replacement [PLACEHOLDER]

We diagnose first and give you a fixed price for the full job before we start. Every regas comes with a 6-month warranty. If the fridge is old and the repair would cost close to the price of a new one, we tell you so.

Regassing safely and legally

Our technicians are registered with SAQCC Gas, which the Pressure Equipment Regulations require for anyone who works with refrigerants in South Africa. You are welcome to ask to see a technician's registration before any work starts.

The short version

A proper regas in four steps

  1. Confirm it is a gas problem

    We test the system first. Many fridges that "need gas" actually have a fan, thermostat or defrost fault.

  2. Find and fix the leak

    We trace the leak with proper leak detection, repair it and fit a new filter drier.

  3. Pressure test and vacuum

    We pressure test the repair, then pull a deep vacuum to remove air and moisture from the system.

  4. Recharge and test

    We recharge with the refrigerant on the rating plate, measured by weight, and check temperatures before we leave.

FAQ

Fridge regassing questions

How do I know if my fridge needs regassing?

The classic signs are a fridge that runs all the time but never gets properly cold, a cooling plate or freezer that only frosts over in one corner, hissing or gurgling sounds, or oily marks on the pipes. The only way to be sure is to test the system, because a failed fan or defrost fault can look the same.

How long does a fridge regas last?

If the leak is found and properly repaired, the gas should last for the rest of the fridge's life, because a sealed system does not use up refrigerant. A regas that only lasts a few months almost always means the leak was never fixed.

Can you regas a fridge-freezer or a bar fridge?

Yes. We regas top-freezer and bottom-freezer combis, side-by-sides, single-door and bar fridges. The process is the same: find the leak, repair it, vacuum the system and recharge it with the correct refrigerant.

Do you regas fridges at my home, and is it guaranteed?

Yes. Regassing is done on site with portable vacuum pumps, gauges, scales and leak detection equipment, so your fridge stays in your kitchen. Every regas comes with a 6-month warranty.

Fridge running but not cold?

Book a proper regas. We find the leak, fix it and recharge your fridge correctly, at your home.

WhatsApp us