The first step with a fridge not turning on is to find out whether power is reaching it, by checking the socket, the wall switch, any multiplug or surge protector, and the DB board. If the supply is fine, the fault is inside the fridge: usually the control board, a thermostat, a start relay or an overload protector, and less often the compressor.
First, how dead is it?
- Not working at all, with no light, display or sound: start with the supply checks below, then suspect the power board, the cord or a burnt connector.
- The light or display works, but the fridge is silent and warming: power is arriving, but the compressor is not starting. Check the settings, then the faults further down.
- It clicks every few minutes: the compressor is failing to start, as our guide to a fridge making noise explains.
- It runs but stays warm: that is a cooling fault, which our fridge not cooling guide covers.
Check the supply, from the wall to the fridge
- Check the plug and cord. Never use a scorched, cracked or melted plug, or a cord crushed behind the fridge. If you find one, switch off at the DB board before you touch it, then unplug the fridge and book a repair.
- Try another appliance in the same socket, such as a lamp or phone charger. If that fails too, the socket or circuit is at fault, not the fridge.
- Check the wall switch, which is easily knocked off when the fridge is pushed back into place.
- Take out any multiplug, double adaptor or extension lead and plug the fridge straight into the wall.
- Allow for a surge protector. It usually waits a few minutes after the power returns before reconnecting the fridge, which is normal, but one that stays off long after its delay may have failed.
- Look at the DB board. Reset a tripped circuit breaker or earth leakage once. If it trips again, unplug the fridge and read our guide to a fridge tripping the electricity.
Settings that look like a fault
- A thermostat dial on 0 or off. On some dials the lowest position switches the cooling off while the light still works, and dials get bumped when the shelves are packed.
- A sleeping or locked display. Many electronic fridges switch the display off soon after the door closes (after about 20 seconds on many LG models) and wake it when you open the door. A lock symbol only locks the buttons, and holding the lock button for a few seconds usually releases it.
- Demo or showroom mode. Shops use this mode to run the lights and display without cooling. A Samsung shows OF OF, and LG calls it demo or display mode. Your manual shows how to switch it off.
Why is my fridge not turning on when the power is fine?
- Control or power board. On an electronic fridge the board runs everything, so a failed board, often after a surge, leaves the fridge dead with a working socket. Boards are model-specific and may need ordering, and we tell you the lead time. See control board repairs.
- Thermostat. On a fridge with a dial, a thermostat that has failed open circuit, so it never calls for cooling, leaves the light on and the compressor silent. See thermostat replacement.
- Start relay or overload protector. These small parts on the compressor can fail after a surge, leaving the compressor silent or only clicking. A new start relay can often be fitted there and then.
- Burnt wiring or a connector. A loose connection heats up until it burns, leaving a smell and a dark mark, and it must be properly repaired.
- Door switch. On many fridges the light runs through a switch the door presses. If it fails, the light stays off although the fridge still cools, so feel whether it is cold inside.
- Compressor. A burnt-out winding or a seized motor leaves it silent or clicking, and it is tested last. See compressor replacement.
After load shedding and other power cuts
When the power returns, a fridge can take several minutes to start. Some hold off the compressor for up to about six minutes, and a surge protector adds its own delay on top.
Do not switch it on and off to wake it. After any stop, the compressor needs a few minutes for the pressures inside to settle, and if it tries to start too soon, the overload protector cuts it off and the wait starts again.
Signs of surge damage are a burning smell, a display that stays dark although the socket works, a new error code, or clicking without cooling. Switch off and unplug a fridge that smells of burning. After a thunderstorm, our Centurion page on lightning and surge damage also covers insurance claims.
Meanwhile, keep the doors closed: the fridge section stays cold for about 4 hours, and the freezer keeps food frozen for about 48 hours when full or 24 when half full. If in doubt, throw it out.
If the supply checks out and the fridge is still dead, book a technician and tell us what still works: the light, the display or any sound. We repair all major fridge brands.