When the fridge is not cold but the freezer is, the cooling system usually works. On a frost-free fridge-freezer, the freezer’s cold air is not reaching the fridge section, most often because of ice on the cooling coil, a stopped fan or a stuck flap in the air duct. Gas is rarely the cause.
How a frost-free fridge-freezer cools both sections
In most frost-free (No Frost) fridge-freezers, all the cold comes from one cooling coil, the evaporator, hidden behind the freezer’s back panel. A fan blows air across it, around the freezer and through a duct into the fridge section. On many models a damper, a small flap in the duct, opens when the fridge needs cooling.
Frost forms on the coil as it works, so every so often the fridge pauses and a heater melts it off. A timer or the control board starts each defrost, and a defrost thermostat or sensor ends it.
The freezer sits against the coil, so it stays cold even when the air barely moves. The fridge is at the end of the duct, so it suffers first.
Why the fridge is not cold but the freezer is
- Ice on the evaporator, the most common cause. If the defrost heater, defrost thermostat or sensor, or the timer or board fails, frost builds up with every cycle until air cannot pass, so the fridge warms over days or weeks. Our fridge ice build-up guide covers ice you can see.
- A failed or iced-in fan. The motor burns out, or ice locks the blade. Scraping or ticking from the back of the freezer usually means the blade is hitting ice (see our fridge noise guide).
- A damper stuck closed. The flap jams, its motor fails or it freezes shut.
- Blocked vents. Food packed against the vents, or ice in the duct after a door was left open, stops the air too.
- A faulty fridge sensor. On electronic fridges, a sensor tells the board when the fridge needs cold air. If it reads too cold, the board sends too little, and a new sensor or thermostat is the fix.
Also check that holiday or vacation mode is off: on many fridges with a display it lets the fridge rise to about 15°C while the freezer runs normally. If both sections are warm, see our guide to a fridge not cooling.
How to tell which fault you have
| What you notice | What it usually means |
|---|---|
| Frost on the freezer’s back panel, or ice around its vents | The coil has iced up after a defrost fault |
| No fan sound with the compressor running and the freezer door switch held in | The fan has failed or is frozen in |
| The fridge works for a few days after a manual defrost, then warms again | A classic defrost fault |
| Fan running, no frost, fridge still warm | A stuck damper, a blocked duct or a faulty sensor |
A full manual defrost is a temporary fix
If the coil has iced up, a full defrost gets the air moving again:
- Move the food to cooler boxes with ice packs and switch off at the wall.
- Prop the doors open and lay towels down, as the drain tray can overflow.
- Leave it off for 12 to 24 hours. The ice hides behind the freezer panel, so the inside looks dry long before the coil is clear.
- Let it thaw by itself. A knife, screwdriver, hair dryer or heat gun can puncture the coil or melt the plastic, so never use one.
- Wait until both sections are cold before reloading.
Unless a door left ajar caused the ice, the fix rarely lasts: the failed part is still failed, so the frost grows back, often within days.
Static fridge-freezers work differently
A static (manual defrost) fridge-freezer usually has no fan or damper. The freezer has its own cooling plate or shelves, the fridge has a plate in its back wall, and one compressor feeds both, usually under one thermostat that senses the fridge plate. So a warm fridge with a cold freezer points to that thermostat or to low gas. A slow leak can starve the fridge plate while the freezer still freezes, and a frost line that stops part of the way across the plate is the giveaway, calling for a proper regas with the leak repaired.
Side-by-sides and dual-cooling fridges
Many side-by-sides and multi-door fridges still have one evaporator behind the freezer and duct its air to the fridge side, so the faults above apply. Others cool each section separately. Samsung’s Twin Cooling models use two evaporators and two fans, and Beko’s NeoFrost models have two separate cooling systems with their own fans. On those, the fault is usually on the fridge side itself: its fan, defrost system or sensor. See our side-by-side fridge repairs page.
How we fix it
We test the defrost parts, fans, damper and sensors first. Common parts such as fan motors and thermostats can be fitted on the spot, and if a model-specific control board must be ordered, we give you the lead time. You get a clear price before we start, the R300 call-out fee is payable only if you decide against the quoted repair, and every repair carries a 6-month warranty. We repair all major fridge brands. Book a repair for a warm fridge with a cold freezer.